Missing data in PCL Reader

Posted on | February 22, 2010 | 1 Comment

When importing a PCL-file I’m missing approx. 16mm at the bottom compared to the “original”. The bottom border is actually 22mm and my printer only needs 6mm. How come?

If I want to use a “watermark/company paper” to “print on” what product is then needed beyond PCL Reader assuming a positive answer to my first qst.

If you enjoyed this post, make sure you subscribe to my RSS feed!

This post was submitted by Jens Holst Sørensen.

Comments

One Response to “Missing data in PCL Reader”

  1. bobp
    February 22nd, 2010 @ 2:04 PM

    It’s difficult to say without being able to analyze the PCL. Since you are describing the measurements in mm, you probably have a PCL file that is expecting the printer’s front panel defaults to be set to A4 paper size. We default to letter paper size. Change via Convert Prefs. -> Front Panel Settings ->

    If you want to print on letter head, then that can be done a number of ways. You will need PCLWorks to create a letterhead overlay macro. Then, you will need to insert the execute the macro in your PCL data file.

    Regards,
    Bob Pooley

Leave a Reply

You must be logged in to post a comment.